AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |
Back to Blog
Deutz F2L411 Manual4/21/2021
Tighten screws. 21 Nm Attention Makes sure that the stop rods are not under stress due to valve overlap when fastening the screws.Reprinting and reproductions of any kind, even in part, require our.Any use above and beyond this is con- The engines made by DEUTZ are developed for sidered improper use.
A wide range of var- be liable for damages resulting from this. The legally prescribed rules for the prevention of ac- There may be deviations in the descriptions, illustra- cidents must be observed. Only use tools without damage to the The DEUTZ Common Rail system used in the chrome plating or tools which are not chrome- DEUTZ engines consists of high-precision compo- plated. The re- materials which can leave behind particles or fi- newed parts operating materials must be stored, bres (cardboard, wood, cloths) may be used. To structure the information to suit the user, the The W job card documents standard repairs on the service documentation is divided into operation engine andor its components. P01 61 valve clearance, inlet 10.Page number Tightening specification 11.Date of issue of job card The necessary values are specified here. Name Screw type Notes Remark Value D 2011 w TD 2011 w TCD 2011 w A00 001 Clamping bracket on crankcase 90 Nm Clamping bracket on adapter for A00 002 90 Nm. Name Screw type Notes Remark Value M8x35-10.9 A09 010 Coolant pump on thermostat housing 20 Nm M8x100-10.9 A09 020 Pipe clip on holder M6x16. Tighten screw (2). Nm 47535-0 Connect adapter (1) to connector. Mount the compression tester on the adapter. Therefore, limit Compression value in bar values cannot be determined exactly. Name Additional information Value 25 - 30 bar P00 51 Compression pressure (2500 - 3000 kPa) Tightening specifications ID no. Remove oil return pipe (4). Mount clamping holder (1). Unscrew eyelet bolts (1). Demounting engine from assembly block Screw in eyelet bolts (1). Mount holder (2). Tighten screw (3). Nm D 2011 w, TD 2011 w, TCD 2011 w Install all mounting feet. IN inlet valve EX exhaust valve Valve overlap means: The inlet valve starts opening,exhaust valve closes. Attention. Tighten lock nut (1). Nm Do not turn the setting screw when tighte- ning the locking nut. Crankshaft position 1 Turn over crankshaft until the valve overlap is achieved on cylinder 1. Tighten all screws (1) alternately. Nm 47540-1 122008 17770-001. Name Additional information Value P00 71 Ignition sequence 1-3-4-2 P01 61 Valve clearance (inlet) 0.3 mm P01 62 Valve clearance (outlet) 0.5 mm. Lay out components in the order in which they should be installed. Visually inspect the components. Installing the rocker arm and rocker arm bracket Insert stop rods (1).
0 Comments
Read More
Leave a Reply. |